Forum / Guestbook




Luberth Fri 17 May 2019 at 8:34:15
Arduino L LED blinking fast and uploading not working

-
Arduino nano L LED blinking fast and uploading not working
did i brick it
Well this Unbricked the NANO


I successfully restored both 2 arduino nano boards using the reset button:

Power off the board (I disconnected the USB cable from computer)
Press and hold the reset button
Connect USB cable (keep holding the reset button)
Click "Upload Sketch"
Wait a second or two until Arduino software says "Uploading..." in the status bar
Release the reset button
Use these steps to upload any small sketch, Blink example is a good choice.





Please Let me Sleep


End of Message, Thanks For Viewing! ☺
Tip: if your watching on your phone or tablet ⁝ add / save to homescreen and you get a nice icon its Free!
Tip: on your computer or laptop do not forget to bookmark this page its Free!
BookMark ShortCut Keys press ctrl+d on your keyboard




-

-

Reply to this Message


Name
Subject
Message

, <code> <b> <i> <u> .






POLL / VOTE
Did you like this Page id=290 ?

NO:         YES:




   


Design a Bit like ForumOne 4.0 WayBack 1999 ©
Always Read the Small print?!



http://forum.luberth.com - - http://www.luberth.com/forum/

NO COOKIES !?

thanks for your support
Thank You!




Co2 FootPrint WebServer



                         My Cheap Chinese Friend Ali     
Copyright Luberth Dijkman 2018 ... 2019