Welcome InMyPi Forum / Guestbook

Charlie Sarsfield Wed 12 Dec 2018 at 8:46:37
CNC 3020T-DJ Mach3 - How To Setup And Operate Its Rotary Axis

Charlie Sarsfield
Published on Dec 15, 2016

In this video,
I go through a complete setup and run utilizing the rotary axis supplied with the machine.
I tried to cover everything. Have any questions, just ask. Thanks for watching.

All background music by

The free g-code software: F-Engrave and G-Code-Ripper

The software machine controller: Mach3

4-Axis 3020T CNC - Parallel Port Version (This is the version I have)

4-Axis 3020T CNC - USB version (NOTE: This USB version is not supported by Mach3)

The Touchpad Keyboard I use as the CNC Pendant...

End of Message, Thanks For Viewing! ☺
Tip: if your watching on your phone or tablet ⁝ add / save to homescreen and you get a nice icon its Free!
Tip: on your computer or laptop do not forget to bookmark this page its Free!
BookMark ShortCut Keys press ctrl+d on your keyboard



Reply to this Message


, <code> <b> <i> <u> .


Design a Bit like ForumOne 4.0 WayBack 1999 ©
Always Read the Small print?!

http://forum.luberth.com - - http://www.luberth.com/forum/

Page Optimized for Netscape Navigator 2.0 or Newer Real Gecko ;-)

Domoticz/#/Floorplans Co2 FootPrint of this RaspBerry Pi 3B+ DeskTop PC & WebServer